Boston Acoustics VS 344 - Manual (Page 4)

4
Adjustable Feet
Each of the VS Series models,
except VS 344, is equipped with
adjustable feet that lets you
change the vertical angle of the
speaker to suit your installation.
The VS speakers are supplied
with an open ended wrench and
a hex wrench to set the position
of the adjustable feet. Put the
hex wrench in the hole in the
bottom of the adjustable foot.
Put the open ended wrench
around the recesses in the base of
the cap. Turn the wrenches to set
the position of the foot.
The VS 336 and VS 344 are supplied
with carpet spikes. If the speakers
are placed on a carpeted floor
replace the feet with the carpet
spikes. This provides additional
stability and coupling for the
speaker. Care should be used with
the carpet spikes to avoid damage
to the floor or injury.
Wall-Mounting
The VS 240, VS 260, VS 224, and VS 325C can be wall-mounted using
the supplied mounting bracket. Use the supplied hex wrench to
remove the foot mounting screw and the foot. Then install the
threaded mounting posts in the back of the cabinet.
Fasten the mounting plate to the wall with appropriate hardware.
See the Note below. Be sure it is level. Connect the speakers. Insert
the heads of the mounting posts through the keyhole openings in
the mounting plate. Lower the speaker to seat the mounting posts
in the mounting plate. When the speaker is positioned horizontally
the vertically positioned keyhole openings are used.
NOTE: The customer is responsible for the correct selection and use
of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers.
To change the angle of the speaker . . .
. . . rotate the feet.
Use the open ended
and hex wrenches to
set the position of the foot. Reposition the foot
for horizontal use
mounting post
mounting plate wall