Brother P2500 - Manual (Page 64)

CHAPTER 2 OPTIONS
2-7
☛ 4.
To install the memory board onto the main control board, use the supplied
spacer and plug the board into the upper left connector of the main control
board.
Fig. 2-4 Install the Memory Board
☛ 5.
Secure the access cover with the two screws.
☛ 6.
Refit the rear cover.
☛ 7.
Reconnect the interface cable from your computer. Plug the power cord into
the AC outlet and turn on the power switch.
☛ 8.
To check that the memory board is installed correctly, you should perform a
Test Print “Print Configuration”. This listing will show the current total
memory size, so you can check that it was updated.