Beckett Water Gardening Pond Filter Kit BF350A20 User Manual
Page 2
STEP 5: Soak both FILTERS with fresh
water. While holding the filters under
water, squeeze the filters and release.
This will get rid of the bubbles, so the
filter will stay grounded and not float.
STEP 6: Place the FINER FILTER first,
then the COARSE FILTER on top the
PUMP and BIO-BALLS with the
EXTENSION TUBE fitting thru the
center hole cutout of each FILTER.
STEP 7: Snap LID in place.
STEP 8: Attach the DIVERTER VALVE
by pushing down. Always have the arrow
shown on the DIVERTER pointed up.
STEP 9: Attach the second EXTENSION
TUBE and the LOWER NOZZLE
HOUSING by pushing down. Choose
between the 3-TIER and the FLOWER
NOZZLE. Twist onto the LOWER
NOZZLE HOUSING.
NOTE: The second EXTENSION and
the DIVERTER may be omitted for
smaller ponds and less height in water
spray.
Indicator is pointed
to the right.
OPEN
CLOSED
OPEN
CLOSED
Indicator is
pointed down.
Indicator is
pointed up.
OPEN
OPEN
To connect to a Spitter, slide one Hose Clamp on
each end of the Tubing. Slide the Tubing over the
Diverter and Spitter’s connection. Close the clamp
over both. Place your Spitter among the landscape
and enjoy!
5/8” Vinyl Tubing, ¾” Hose Clamp and Spitter not included.
Page 2