Britax Wizard - Manual (Page 11)

Installation: Forward Facing
19
Installation: Forward Facing
18
4 Rotate the forward facing lock-off
down to open.
• Only use lock-off farthest from where the
vehicle belt is buckled.
5 Remove slack from the lap portion of
the vehicle belt.
6 Push the child restraint firmly into the
vehicle seat while pulling the shoulder
portion of the vehicle belt tightly
through the lock-off to remove slack
(Fig. D).
7 Hold the shoulder belt tight, then rotate
the lock-off upward until it clicks in
place (Fig. E).
• Lock-off is not engaged and vehicle belt is
not secured until a click is heard.
8 Verify that the vehicle belt is tight and
the child restraint is secure.
• See Checking Buckle Position on page 26.
• Installation can be improved by the use of the Versa-Tether ® (see pages
23–25).
R Reem mo ovvaall::
Open lock-offs, then unbuckle and remove vehicle belt from belt
path. Disconnect Versa-Tether
® , if attached.
Forward Facing
Lap-Shoulder Belt Installation
• Figure A illustrates the forward facing lap-
shoulder vehicle belt route.
• When not in use, always store the LATCH
connectors in storage pouches sewn in
cover above rear facing lock-offs.
1 Place the child restraint forward facing
on the vehicle seat.
• Restraint must be in the full upright
position when installed in forward facing
mode with children over 33 pounds (15kg).
• If installing with Versa-Tether ® , remove
tether from pouch and loosely attach to an
approved tether anchorage point before
continuing. See pages 23–25 for complete
Versa-Tether instructions.
2 Pull the vehicle belt out, then pass it over
the LATCH bar, through the forward
facing belt slots, then over the LATCH bar
on the other side (Fig. B).
3 Verify that the vehicle belt is not
twisted, then buckle (Fig. C).
B
A
E
D
C
P2285_R02c.qxd 12/8/2003 12:19 PM Page 20