Hinkley Lighting MARCELLINA 4400GR - Manual


assembly instructions
Family: Marcellina Item No. 4400 GR
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading 1-5/8” nipple (C) into the center hole of
the mounting strap (A), up against hex nut approximately 1/4“ - see Drawing 1.
2. Attach mounting strap (A) to junction box (J) using two 1” screws (B) provided.
1. To mount fixture, slip center hole of backplate (E) over nipple (C) and hold fixture in
position - see Drawing 1.
2. Thread decorative knob (D) onto end of nipple (C) and tighten to secure fixture.
1. Slip candle sleeve (1) over socket - see Drawing 2.
2. Slip glass bobeche (2) over candle sleeve (1).
3. Slip glass cup (3) over candle sleeve (1).
4. Fixture can now be lamped accordingly
5. Hang crystal (4) at location indicated.
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then completing assembly of fixture.
start here
4400
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 4400 fixture is 60 watts per bulb.
Drawing 1 - Fixture Mounting
Drawing 2 - Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
2
1
3
4
A J
B
C D
E
2.10.09