Hinkley Lighting KARMA FR41950PAL - Manual (Page 2)

FRIS19-70T
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove the
appropriate fuse (or open the circut breakers) until the fixture is dead.
• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.
STEP 2
1 Take swivel (g) and thread tube with hex nut into mounting strap (e)
approximately 1/2” -see Drawing 1.
2 Temporarily install mounting strap (e) with swivel (g) onto junction box.
slip canopy (d) over swivel and up to ceiling and adjust swivel height, when
adjusted correctly tighten hex nut (h) against mounting strap (e) to lock in
position. Remove strap and swivel from junction box - see Drawing 1 & 2 .
4 With assistance, lift fixture with stems (b) and crossbar with swivel (e) previously
attached and mount to the junction box (j) with two screws (f).
STEP 3
1 Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet (I.S. 18) and follow all instructions to make all neccessary
wiring connections.
2 Slip canopy (d) up along rods (b) and cover mounting crossbar with swivel (e).
3 Slip retaining ring (c) up to canopy and thread onto coupler (g), located on the
mounting crossbar with swivel (e), to secure canopy.
[DRAWING 1]
01.01.13
j
e
f
f
g
d
c
b
h
1/2” of thread
showing
[DRAWING 2]
3 Slip, in this order swivel collar (c) and canopy (d) over stems (b),
Now slip mounting strap (e) with swivel (g) along supply wire and thread swivel
into top of stem (b).