Hinkley Lighting 6.5FT POST WITH CAST ALUMINUM BASE 6638 - Manual (Page 2)

METAL
TEMPLATE
W/ BOLTS
ELECTRICAL
SUPPLY
WIRE
BOLT PATTERN
120
DEGREES 4-1/2”
9” bolt circle
use metal template provided with pole check local building codes prior to installation
POST
BASE
CAP
NUT
HEX NUTS CAN BE
ADJUSTED TO
INSURE
POLE IS PLUM
4. MOUNTING LAMP POST TO FOOTING
1. Thread hex nuts onto anchor bolts and adjust to that the tops of the hex nuts are 1-1/4” above the
footing - see Diagram C
2. Slip flat metal washer onto anchor bolts.
3. Slip pole base over anchor bolts and check for plum. If pole is not plum adjustments can be made to
hex nuts under base to correct any leaning.
4. When pole is plum finish installation by threading on the and tightening the cap nuts provided.
FOOTING DETAIL VIEW
Diagram C
FLAT WASHER
revised 12-01-10 grand