Hinkley Lighting BOLLA 4664OB-OP-LED - Manual

assembly instructions
Family: Bolla Item No. 4664 BN/OB
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the glass.
start here
46
64


SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To assemble main body, remove loop (10) and canopy plate (11) from center column
assembly (4).
2. Attach arms (3) to fixture column assembly (4) using lock washers (2) and hex nut (1).
3. Replace plate (11) and thread loop (10) onto center column assembly (4).
4. Please refer to the hanging instruction sheet (I.S. 19) provided to continue
installation of this fixture. Then refer back to this sheet to install glass.
1. Prior to installing glass, fixture can now be lamped accordingly.
2. To install glass, thread knob (8) onto end of stem (12), and slip stem through
bottom assembly (7) - see Drawing 1.
3. Slip glass (6) over stem (12).
4. Slip rubber washer (14) and washer (15) over stem and thread nut (16) onto end of
stem (13).
5. Thread knob (8) onto end of stem (5).
6. Line up the holes on the arms (A) with the threaded stud (B) extending out from
end of arm (3).
7. Thread ball knob (9) onto end of stud (B).
3 2 1
4
Drawing 1 - Fixture Assembly
10
11
15
14
B
A
9
7
6
8
13
12
2.7.08
center hole of
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com