Blue Rhino FC-0007 - Manual (Page 135)

OPERATION
SE6 05/05 Operation Section 4-43
© 2005 Alamo Group Inc.
OPERA
T
ION
Shear Pin Shears Tractor PTO not being run at Run at 540 RPM.
Excessively 540 RPM.
Heavy Material.
Reduce ground speed. Raise cutting
height.
Not using proper pin. Replace only with recommended shear
pin.
PTO engaged at high engine RPM Idle engine to engage PTO
Cutting in rocky conditions Increase cutting height.
Blade carrier RPM too high. Check gearbox ratios.
Blades not properly heat treated. Consult your Dealer.
Rapid Clevis Wear Washers not used. Install washers above & below drawbar
Clevis ending or spreading Using pin or bolt not tightened. Use 3/4” gr5 or 8 bolt & tighten nut.
open.
Tongue bending or binding Improper Drawbar. Add attaching Plate to all 3-Point
in turns. drawbars. See section on attaching
mower to tractor.