Brinkmann Rechargeble Spotlight 800-2655-2 - Manual (Page 7)

Charging Tips To Prevent Damage to Spotlight and Battery:
• Do not attempt to use spotlight while charging directly from AC outlet.
Doing so may cause damage to battery and AC charger.
• 12-volt DC charger/adapter operates from a cigarette lighter
receptacle for charging battery in spotlight only while vehicle engine
is running or continuous corded operation with or without battery.
• Do not attempt to charge battery pack using both AC an DC chargers
at the same time.
• Only use charging devices that are provided with the Q-Beam Max
Million
IIII Rechargeable Spotlight or its replacements.
• For DC Charger/Adapter - Battery charges only while vehicle engine is
running.
For AC Charger - Allow battery to fully charge. L.E.D. indicator on
battery will automatically turn off when battery is fully charged.
See chart for recommended charge times.
• Do not allow battery to completely discharge. A dim light indicates a low
battery. Recharge battery as soon as possible after each use.
• Always keep the battery fully charged when not in use.
10
4 6 8 10
20
DC Charge
AC Charge
USAGE
(Minutes)
CHARGE TIME (Hours)
Charge Times
Charge times are dependent on usage of the
product. See chart below for recommended charge times.
6
To Replace Cigarette
Lighter Plug Fuse
Lighter Plug
Lighter Cap
Lighter Plug
Lighter Plug
Lighter Cap
Fuse
Fuse Holder
Lighter Cap
Lighter Cap
Step 1: Disconnect spot/flood light from power source.
Step 2: Unscrew cap of lighter plug and pull straight away from fuse.
Step 3: Pull fuse holder and fuse out of lighter plug. Observe to see if
fuse is burned out.
NOTE: Use a 8A fuse only. Fuse is burned out when fuse element is
missing or broken inside glass tube. Replace with new 8A fuse
if fuse element is missing or broken.
Step 4: Pull fuse out of fuse holder. Insert new fuse into holder.
Step 5: Insert fuse holder and fuse into lighter plug.
Step 6: Screw cap onto lighter plug.
INSTR_800-2655-2_MM2_10-05.qxd 10/14/05 10:48 AM Page 7