E-flite AT-6 Texan 25 ARF - Manual (Page 25)

25 E-flite AT-6 Texan ARF Assembly Manual
 3. Using a ruler, mark the servo cover as shown
using a pencil.
 4. Position the servo so the arm is centered at the
intersection of the lines drawn in the previous step. Use a
pencil to mark the cover for the servo mounting blocks.
 5. Use 6-minute epoxy to glue the servo mounting block
to the servo cover as shown. Allow the epoxy to fully cure
before proceeding.
Note: You will find the servo mounting blocks in your
kit to vary in length from the measurements listed
above. They have been cut to the correct length from
the manufacturer.