E-flite Hawker Hurricane 25e PNP - Manual (Page 17)

17 E-flite Hurricane 25e PNP/BNF Assembly Manual
EN
 4. Use two-sided tape to secure the receiver in the
fuselage as shown.
 5. Place the longer antenna into the groove in the
inside of the fuselage. Use clear tape to keep the
antenna in the groove so it doesn’t interfere with the
operation of the servos.
 6. The shorter antenna is routed to the front of the
fuselage. There is no need to tape it in position.
Wing Installation - BNF/PNP
Required Parts
Fuselage assembly
Wing assembly
3mm x 15mm machine screw (4)
Required Tools and Adhesives
Phillips screwdriver: #1
 1. Position the wing so the pins in the forward
wing dowel plate fit into the plate in the front of the
fuselage. Guide the leads from the aileron and flap
servos (and optional retracts) through the hole in the
bottom of the fuselage.
 2. Use a #1 Phillips screwdriver to tighten the four
3mm x 15mm machine screws that secure the wing.
Two screws are used in the rear wing bolt plate and
two in the center wing bolt plate.
 3. Connect the aileron and flap (and optional
retract) leads to the appropriate Y-harness at the
receiver.