E-flite Ultimate Fx 3D ARF - Manual (Page 23)

23
Linkage Installation
Required Parts
Airframe
Long servo arm (3)
Micro control connector (4)
Control connector backplate (4)
2mm x 3mm screw (4)
Micro pushrod keeper (6)
Micro control horn (4)
Micro control horn backplate (4)
Rudder linkage wire, 12" (305mm)
Elevator linkage wire, 5
1 /
8
" (130mm)
Aileron linkage wire, 5 5 /
16
" (135mm) (2)
Aileron inter-connection linkage wire, 7 1
/
8
" (180mm) (2)
Required Tools and Adhesives
Foam compatible CA
Phillips screwdriver (small) Felt-tipped pen
  1. Attach the micro control horn to the elevator using
the micro control horn backplates. Apply a few drops
of foam compatible CA to the backplate where it meets
the control horn.