E-flite Sobre 3D Profile - Manual (Page 24)

 E-flite Sobré 3D Profile Assembly Manual
Landing Gear Installation
Required Parts
Airframe
Landing gear strut (2)
Wheel retainer (4)
Wheel pant (2)
1.5-inch (38mm) foam wheel (2)
Landing gear support disk (2)
Required Tools and Adhesives
Foam-compatible CA
The landing gear is optional. If you plan on saving
weight, or flying from very rough surfaces, it is suggested
to skip this section.
  1. Locate the landing gear strut, two wheel retainers
and the wheel. Use Foam-compatible CA to install
the wheel retainer onto the strut. The retainers will
sandwich the wheel in position.
Note: Use care not to get CA on the wheel, preventing it
from rotating on the strut.
  2. Pass the landing gear through the opening in the
fuselage and wing. DO NOT use glue until instructed
to do so.
 3. Repeat Steps 1 and 2 for the remaining strut.