E-flite Ascent EP Park Glider ARF - Manual (Page 11)

Parts Needed
Fuselage assembly
Sub-Micro Servos (2) (JRPS241)
Tools and Adhesives Needed
Phillips head screwdriver
Step 1. Install the mounting hardware (grommets & eyelets)
supplied with your servos. Also remove the servo arms at
this time.
Step 2. Install the servos into the preinstalled servo tray in the
fuselage. Position the servos as shown with the output shaft
towards the nose of the plane. Be sure to feed the servo leads
through the hole at the forward portion of the tray.
Note: The elevator servo is mounted on the left, and the
rudder servo is mounted on the right.
Step 3. Secure the servos in place using the mounting screws
supplied with the servos.
12
Section 3: Installing the Elevator and Rudder Servos
A
B