E-flite Carbon-Z Cub PNP - Manual (Page 12)

EN
®
Wing Installation
Before each fl ight, ensure all wing connectors and fasteners are secure.
Assembly
Assemble both wings using the following steps. (Only the right wing shown)
1. Install 6 vortex generators (A) in the wing channels (B) by using double-
sided tape (C).
2. Install the vertical bracket (D) on the wing mounts using 2 screws (E) and
2 lock nuts (F).
TIP: DO NOT overtighten lock nuts on the screws. Ensure the vertical
brackets can pivot freely on the wing mounts.
3. Install the wide front strut (G) on the front strut mounts using a screw (H)
and lock nut (I).
4. Install the narrow rear strut (J) on the rear strut mount using a screw (K)
and lock nut (L).
TIP: DO NOT overtighten lock nuts on the screws. Ensure the struts
can pivot freely in the strut mounts.
5 Attach the vertical bracket to the struts using 2 pins (M) and 2 R-clips (N).
E D
F F
G
J J
H
I L
K
N M
A
C
B
A A A
C
B
12