E-flite T-34 Mentor 25e ARF - Manual (Page 8)

8 E-flite T-34 Mentor 25e ARF Assembly Manual
 8. Use a pin vise and 5/64-inch (2mm) drill bit to
enlarge the holes in the servo arm that are 1/2-
inch (14mm) and 3/4-inch (20mm) from the center
of the HD servo horn.
 9. Insert the brass pushrod connector in the
hole that is 1/2-inch (14mm) from the center of
the servo horn. Use a nylon pushrod connector
backplate to secure the connector.
 10. Center the rudder servo using the radio system.
Use a #1 Phillips screwdriver to install the servo
horn prepared in the past few steps on the rudder
servo.
 11. Use a pin vise and 5/64-inch (2mm) drill bit to
enlarge the hole on the elevator servo horn that is
1/2-inch (13mm) from the center of the horn.
 12. Slide the 23 1 /
4
-inch (590mm) elevator pushrod
wire into the tube in the fuselage. Insert the bend in
the enlarged hole in the servo horn as shown.