Blackline GPS LonerGPS - Manual (Page 10)

10
Alternatively, LonerGPS may be worn in a pocket, however the mobile worker should ensure that the logo
side of the enclosure should face away from their body.
Note
Note Note Note - BlackLine recommends using the supplied holster to ensure optimum GPS tracking performance
and to ensure audibility of the internal beeper.
Us Us Us Use Procedure e Procedure e Procedure e Procedure
The device should be powered when safety-monitoring is required Using the LonerGPS safety device is
very straightforward:
• The mobile worker presses the power button to turn LonerGPS on (please see the following
section on turning LonerGPS on and off for further information)
• The mobile worker wears LonerGPS on his or her belt
• The mobile worker goes about their duties with little additional burden
Note
Note Note Note – BlackLine recommends that the LonerGPS device remain powered during an entire work shift.
Please see the note below regarding lunch and coffee breaks.
Turning LonerGPS On and Off
Turning LonerGPS On and Off Turning LonerGPS On and Off Turning LonerGPS On and Off
To turn LonerGPS on, press and release the power button. To turn the LonerGPS device off, press and
release the power button. The LonerGPS device features a wireless connection / power indication. When
the green indicator light blinks, the LonerGPS device does not have a wireless data connection. When
the indicator light changes to solid green (continuous), the LonerGPS device is connected to the wireless
network. It takes approximately 30 to 90 seconds to achieve a wireless data connection, depending on
the wireless signal level.
Note
Note Note Note - BlackLine recommends that during breaks that the mobile worker continue to wear LonerGPS with
the device powered. The benefit of not forgetting to turn it on after the break outweighs the risk of
forgetting to turn it on, in order to save the occasional pending No-motion Alert beeping.