E-flite Tensor 4D ARF - Manual (Page 35)

35
Landing Gear Installation
Required Parts
Assembled airframe Landing gear (2)
1 1 /
2
" wheel (2) Wheel stopper (2)
Wheel pant (2)
Required Tools and Adhesives
Foam-safe CA
 1. Place the wheels on the landing gear. Check
that they can roll freely. Enlarge the hole in the
wheel if necessary. Use a wheel stopper and
foam-safe CA to retain the wheel.
Note : Be very careful not to get CA onto the
wheel, preventing it from rolling.
 2. Slide the gear into position, but do not glue it
yet. The end of the gear will rest in the hole on
the fuselage spine support.
 3. Repeat Steps 1 and 2 for the remaining landing
gear and wheel.