E-flite DHC-2 Beaver 25e ARF User Manual
Page 12
12
E-flite DHC-2 Beaver ARF Assembly Manual
3. Use hook and loop tape to mount the speed control to
the front of the battery box as shown. You will need to
attach a 9-inch extension onto the ESC plug to route it to
the receiver.
4. Plug the leads together between the motor and speed
control. Secure the wires so they will not interfere with the
operation of the motor.
5. Use a hobby knife and rotary tool to remove the area
in the center of the dummy radial engine. Use a hobby
knife to remove the area between each of the cylinders to
allow cooling air to pass through the cowling and over
the motor. Use 6-minute epoxy to glue the dummy radial
engine inside the cowling. Use the following colors to
paint the dummy radial engine.
Note: We used the following colors when painting
the engine:
Rocker Shafts – Aluminum
Engine Cylinders – Black
Plug Wires – Yellow
Center Crankcase – Lt. Gray