E-flite Alpha 450 Sport ARF - Manual (Page 19)

19 E-flite Alpha Sport 450 ARF Assembly Manual
Attaching the Wing and
Centering the Ailerons
Required Parts
Fuselage assembly Wing panel (right and left)
Wing tube
#4 steel washer (2)
Wing bolt plate Motor battery (charged)
Transmitter
4-40 x 3/4-inch socket head bolt (2)
Required Tools and Adhesives
Ruler Phillips screwdriver: #0
Threadlock
Hex wrench or ball driver: 3/32-inch
Optional Tools and Adhesives
6-minute epoxy Paper towel
Rubbing alcohol Epoxy brush
Mixing stick Mixing cup
Low-tack tape
 1. Slide the wing tube in the socket in the root end
of the wing. The tube will slide in easily. Do not force
the wing tube in farther than it can easily slide.
 2. Slide the remaining wing panel on the wing
tube. The pin at the rear will fit into the hole in the
opposite wing panel.
 3. The wing panels will fit tightly together. This is
necessary for the wing to fit on the fuselage.
OPTIONAL - EPOxY ThE WING hALvES
As an option, you can use epoxy to join the wings
together of your Alpha 450. Make sure your vehicle
is large enough to accept the assembled wing before
gluing the two panels into a one-piece wing.
 A. Mix 1/2 oz (15ml) of 6-minute epoxy. Use
an epoxy brush to apply a thin layer of epoxy to
the exposed plywood on the left and right wing
panels as shown.