E-flite Yak 54F 3D ARF - Manual (Page 8)

8
 2. Install the hinges into the aileron. Slide the
aileron hinges into the wing until there is a
slight 1/64" gap between the wing and aileron.
Apply foam-safe CA to each hinge, top and
bottom. Do not use accelerator during this
process, as the CA must soak into the hinge.
Remove excess CA with a tissue or paper towel.
 3. Locate the four 20mm x 80mm tape pieces.
Place the tape on the top and bottom along the
hinge line starting at the inside end (root) of the
aileron continuing past the hole for the control
horn. This will reinforce the aileron and help
prevent stress on the control horn. Repeat this
step for the other wing panel.