E-flite Celectra 4-Port 1S 3.7V 0.3A DC Li-Po Charger - Manual (Page 3)

4 5
• Slide the battery into any open slot on the charger. The end-cap of the battery has
been specifically designed to allow the battery to be slid into one of the slots easily
one way (usually with the label on the battery facing outward) to prevent reverse
polarity connection. However, please be sure to check for proper alignment and
polarity before proceeding to the next step.
• Gently press the battery and its connector into one of the charge jack/connectors
located at the bottom of the slots on the charger. Again, be sure to check for and to
achieve proper polarity before making the connection. DO NOT FORCE THE BATTERY
INTO THE SLOT.
• After you make the connection successfully, the LED light on the charger port being
used will turn solid red, indicating that charging has begun.
• It will take approximately 30–40 minutes to charge a fully discharged (not
overdischarged) 70mAh–110mAh battery. As the battery nears full charge, the LED
light will begin to blink. When the battery is fully charged the LED light will blink
approximately every 20 seconds or will go out entirely.
Note: Do not leave charged Li-Po batteries connected in any of the charge ports for
long periods of time.
Using the optional 6V, 1.5-Amp AC/DC Power Supply (EFLC1005)
The Celectra 4-Port 1-Cell 3.7V 0.3A DC Li-Po Charger was designed to be compatible
with the E-flite 6V, 1.5-Amp AC/DC Power Supply.
NEVER attempt to power the charger from an AC outlet without the use of a proper AC to
DC adapter/power supply.
Note: When using the AC to DC adapter/power supply, the Celectra 4-Port Charger
is designed to bypass the D-size battery circuitry to prevent damage. It is still
highly recommended that you remove D-size batteries when connecting your
charger to a compatible AC/DC adapter/power supply. Do not insert charged
or discharged Li-Po batteries in any of the charge ports if the power supply is
connected to the 4-port charger while power supply is not connected to a power
source.
NEVER LEAVE THE ADAPTER/POWER SUPPLY OR CHARGER PLUGGED IN UNNATTENDED.
Celectra 4-Port Li-Po Charger Warning
Lithium Polymer (Li-Po) batteries are significantly more volatile than other rechargeable
batteries used in RC applications. Failure to read and follow these instructions and safety
precautions may result in fire, personal injury and damage to property.
E-flite, Horizon Hobby, Inc., its retailers, and any other representatives, assume
absolutely no liability for use of this product or failure to comply with these instructions
and precautions.
If you are not prepared to accept complete liability for the purchase and/or use of this
product, you are advised to return it new and unused to the place of purchase immediately.
Never ship batteries without the expressed permission of the recipient. Batteries
carryinga charge of 25% or more cannot be shipped safely. Batteries which are damaged
cannot be shipped safely. Damage or loss due to unsafe shipping is the legal responsibility
of the person who shipped the product.