Garden Sun Heater HSS-RS-GH Bullet - Manual (Page 6)

6
ASSEMBLY INSTRUCTIONS
Hardware Used
AA
BB
Hardware Used
1
2
3
1. Attach wheel assembly (I) to base (H). Line up holes
in wheel bracket with corresponding holes in base, insert
two bolts M8 x 16 (BB) through holes, and finger tighten
two M8 flange nuts (AA) . Be sure that the wheel assembly
is parallel to the base, and fully tighten bolts. To improve
the stability, bucket must be filled with sand.
2. Attach three support brackets loosely to base with
three bolts M8 x 16 (BB) downward through support
brackets into the Base.
3. Install post onto three support brackets. Attach
post to support brackets using six bolts M6 x 30 & six
M6 flange nuts. Fully tighten all of the screws.
x 2
Bolt M8 x 16
M8 Flange nut
x 2
BB Bolt M8 x 16 x 3
CC x 6 M6 Flange nut
EE Bolt M6 x 30 x 3
Hardware Used
EE
E
CC
H
AA
BB
I
Fill sand