Garden Sun Heater HSS-A-FXPC Ratton Square - Manual (Page 10)

10
ASSEMBLY INSTRUCTIONS
Hardware Used
DD
HH
11
12
11 . Support heater. Slide three washers washer ĭ8 (DD )
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washer
Vĭ8 on spacers and
securely tighten wing nuts (HH) but do not overtighten.
12. Connec t hose and regula tor to cylinder .
The propane gas and cylinder are sold separa tely.
Use a standard 20 lb. propane cylinder only.
Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for
storage and handling of liquefied petroleum gas,
ANSI/NFPA 58. Your local library or fire department
should have this book.
A minimum supply pressure of 0.4 p.s.i. is required for
the purpose of input adjustment for propane gas. Storage
of an appliance indoor s is permissible only if the cylinder
is disconnec ted and removed from the applian ce. A
cylinder must be stored outdoors in a well-ven tilated
area out of the reach of children . A disconnected cylinder
must have dust caps tightly installed and must not be
stored in a building , garage or any other enclosed area.
The minimum permis sible gas supply pressure of 10
W.C. is required for purpose of input adjustment.
The minimum hourly of 17000 Btu is required input
rating for a heater for automatic operation at ratings less
than full input rating.
The pressure regula tor and hose assembly supplied
with the applian ce must be used.
The installation must conform with local codes, or in the
absence of local codes,with national fuel gas code,
ANSI Z223.1/NFPA54, natural gas and propane
Installation Code, CSA B149.1, or propane storage and
handling code, B149.2.
x 6
:DVKHUĭ
Standard 20 lb. tank
x 3
Wing nut
HH
DD