GBC AutoUltima Pro Laminator - Manual (Page 7)

7
G
AutoUltima Pro – Load Film
IF POSSIBLE, ALWAYS LOAD FILM BEFORE RUNNING COMPLETELY OUT.
1 Cut laminating film as indicated. If
film is not present see next page.
5 Insert and lock Idler Bar Assembly,
then close 4 EZ Load levers.
2 Open all 4 "EZ" Load levers and
remove film.
4 Insert new film, overlap film on
Heat Shoe.
Note: Match colours of film core
ends to EZ Load Levers.
3 Remove Idler Bar Assembly, then
press "Heat" button.
Heat
Button
6 Press feed switch (forward) and
hold until wrinkle-free lamination.
Close top.
7 Scroll up or down to select film
thickness. Press "Enter" to
confirm. Press "Start" to resume
lamination. To reset film thickness,
hold enter button for 5 seconds,
select film thickness then press
"Enter". Screen