GBC W15 WireBind - Manual (Page 4)


Special notice
Thank you for choosing a GBC Binding Machine. We aim to
produce quality binding machines at an affordable price, with
many advanced features to enable you to create excellent
results every time. Before using your machine for the first time,
please take a few minutes to read through this guide.
Specifications
GBC WireBind W15
15 sheets (80 gsm)
1 sheet PVC Plastic Cover (0.18mm)
DIN A4 (297mm)
34 loop wire Binding
125 sheets
14mm
7.3kg
400mmx330mmx130mm
Max Punch Capacity
Max Punch Capacity
Max Document Size
Punching Pattern
Max Bind Capacity
Max Wire Size
Net Weight
Dimensions (LxWxH)
Safety instructions
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS
IMPORTANT TO ACCO BRANDS EUROPE. IN THIS INSTRUCTION
MANUAL AND ON THE PRODUCT ARE IMPORTANT SAFETY
MESSAGES. READ THESE MESSAGES CAREFULLY.
m
General safeguards
• Please read the instructions and keep them safe for future
reference.
• When using the machine, always ensure the machine is on a
flat and stable surface.
• Keep out of reach the reach of children at all times.
• Do not tamper in any way with the internal mechanisms of
this machine.
• Do not immerse in liquid.
• Test the punching system with a scrap piece of paper first.
• Take care that there are no staples or such like in the
document prior to punching.
• Do not place anything in the punching entry other than paper
up to 15 sheets (80gsm) or one PVC plastic cover up to
0.18mm.
• Only carry the machine using the carry handle, never the
punching arm.
• Empty the clippings tray regularly.
Setting up
1 The handle needs to be installed onto the shaft to the right
of the machine. Slot the handle onto the shaft and secure
with the screw.
2 Retain the packaging in case you need to return the
machine for repair. Place on a secure, stable surface.
3 The punching mechanism is coated with a protective film,
which will mark your paper. To clear this, punch scrap
sheets of paper until clean prior to punching.
Punching the document
1 Lift the lid and punch handle to the upright position. Insert
the document into the punch throat, maximum 15 sheets at
a time. Jog the sheets until they are flush against the paper
stop. (see fig 1)
Important: Always set the wire closure control to the
Punch Point setting during punching. (see fig 1a)
2 Pull the punch handle towards you until all papers have
been punched. (See fig 2) Then, return the punch handle to
its original position and remove the paper from the punch
throat. Repeat this operation until all papers have been
punched.
Important: If punching PVC covers, insert no more than
one cover at a time as this material, in large quantities,
could cause jams or excessive wear. It is recommended to
punch PVC cover along with 1 sheet of normal paper. This
will allow better punching holes quality.