GBC C100 CombBind - Manual (Page 3)

Settings adjustment
Set the Edge Guide (Fig 1, A) to the paper size guide, as marked
on the machine. To determine the correct coil size to use on your document slide the Binder
Sizer open (Fig 1, B). Place the document, including the covers, under the
Binder Sizer. Release the Binder Sizer and select the coil that corresponds
with the size shown by the guide. 1 2
Punching paper
Collate the documents, make sure that the document is aligned correctly
and insert the edge to be bound into punch throat (Fig 1, C). Jog the
sheets until they are flush against the edge guide and the bottom of the
punch throat. Hold the sheets in place with one hand. To punch the paper, pull the Punch Handle (Fig 1, D) towards you. Pull all
the way down to punch completely through the paper. Punches up to 12
sheets of 80gsm paper at once. Punch only 2 clear covers at a time to
prevent jams or excessive wear. 1 2
Feeding the coil onto the document
Simply feed the coil by hand into the first few holes in your document
and continue to twist the coil through the holes until it is all the way along
the document (Fig 2). 1
Crimping
To begin cutting and crimping, lay the document on a tabletop surface with
the coil bound edge facing you.
Place the crimpers in your right hand with the red dot facing up (Fig 3).
Working on the right side of the document, place the mouth of the
crimpers around the coil coming through the first hole in the document.
Quickly squeeze the crimper handles together to cut and crimp in one
motion. It is not necessary to twist the crimpers.
Flip the document over and repeat steps 2 to 4 for the uncrimped end.
For left-handed operation, simply perform the crimping operation on the
left end of the document with the red dot facing down.
1
2
3
4
5
6
Guarantee
Operation of this machine is guaranteed for one year from date of purchase,
subject to normal use. Within the guarantee period, GBC will at its own
discretion either repair or replace the defective machine free of charge. Defects
due to misuse or use for inappropriate purposes are not covered under the
guarantee. Proof of date of purchase will be required. Repairs or alterations made by persons not authorised by GBC will invalidate the guarantee.
It is our aim to ensure that our products perform to the specifications stated.
This guarantee does not affect the legal rights which consumers have under
applicable national legislation governing the sale of goods.
Set up
• Unpack carefully and place the CoilBind C100 on a flat surface, ideally
74cm from the floor. When lifting the machine, lift from the bottom. Do not
carry the machine by the handle.
Getting started
• Push the handle (Fig 1, D) onto the shaft on the right side of the machine.
• Align the flat spot of the handle with the flat part of the shaft and secure
using a flat (–) screwdriver.
Safety instructions
• Please use the CoilBind C100 only for its intended purpose of punching
and binding paper and covers according to the indicated specifications.
ƽ
COILBIND C100
╞