GBC 230E MultiBind - Manual (Page 5)


G
Setting up
• Your machine is ready to use when removed from the box.
Retain the packaging in case you need to return the machine
for repair.
• The punching mechanism is coated with a protective film of
lubricant, which will mark your paper. Clear this by punching
scrap sheets of paper until clean prior to binding.
MultiBind 230E is approved to EN60950 and CE Standards.
Technical data subject to change without notification.
Setting up - 230E
• Connect the binder to the electricity supply with the power
cord supplied.
• Switch ON using the ON/OFF switch located at the rear of the
binder by the power inlet socket.
• Wait while the binder goes through an automatic check
procedure, both LED’s light up.
• When complete the green LED will remain ON.
• The binder is ready for operation.
WARNING: This appliance MUST be earthed.
If in doubt consult a qualified electrician.
m
Maintenance options
• If you would like to extend your warranty coverage beyond
the stated manufacturers period, please consult your local
ACCO Brands Europe reseller for options.
Troubleshooting
• This machine has a recommended duty cycle of 5 operations
per minute, up to a maximum of 30 minutes on / 30 minutes
off.
• This machine is fitted with a thermal overload safety feature.
In extreme circumstances, the motor may overheat which
will activate the safety feature. This feature will prevent the
machine punching until it has cooled sufficiently.
• The thermal overload switch will automatically reset after
approximately 15 minutes. The machine will then operate as
if it had been overloaded (see step 4 below).
Security
A security slot is fitted for use with leading makes of security
leash. E.g. Kensington Microsaver.
Maintenance
Please ensure the clippings tray is emptied on a regular basis.
This may prevent your machine from overloading.
MultiBind 230E:
When the clippings tray is full, a yellow LED will be lit. Empty
the contents of the tray to continue binding.
Guarantee
Operation of this machine is guaranteed for two years from
date of purchase, subject to normal use. Within the guarantee
period, ACCO Brands Europe will at its own discretion either
repair or replace the defective machine free of charge. Defects
due to misuse or use for inappropriate purposes are not
covered under the guarantee. Proof of date of purchase will be
required. Repairs or alterations made by persons not authorised
by ACCO Brands Europe will invalidate the guarantee. It is our
aim to ensure that our products perform to the specifications
stated. This guarantee does not affect the legal rights which
consumers have under applicable national legislation governing
the sale of goods.
Register this product online at www.accoeurope.com