GBC Ezload Roll Seal Laminator - Manual (Page 3)

3
Power & Ready Lamps.
Clear indication that unit is both
On and Ready to laminate.
Run/Stop/Reverse
Simple 'Rocker' Switch to
engage motor for Lamination,
Stop or Reverse.
Temperature Control Knob
Up to 10 settings for any of the
five standard film thicknesses
(42.5, 75, 125, 175 and 250
micron) in Matt or Gloss.
Bottom Film Roll
Same EzLoad ™ Film Loading
Technology ensures no confusion
with Top Roller. Access only after
Feed Tray removal.
The Film Selection
RollSeal ™ EzLoad Films are made from high
grade Polyester a low melt adhesive (EVA) layer
making them ideal for a broad spectrum of
paper types/weights and printing techniques.
Available in three finish combinations -
and four standard weights (see overleaf):
• Matt. Non-Reflective and tactile
• Matt/Gloss Combination of 1 + 1
• Gloss. Eye-catching & colour enhancing.
All Rolls are 305mm wide to accept the
Din A4/A3 (short edge) paper standard.
Rear Slitter.
Built into the chassis of
EZLoad
™ 35 is a horizontal
Slitter that can be used to
trim the film/media as it
exits from the Laminator.
Colour Coded Plugs.
All Rolls are fitted with the colour
coded and matching male/female
EzLoad
™ 'plugs' that ensure
replacement Rolls are correctly loaded.
EZ Load Film Loading Technology
Colour Coding and matching Male/
Female plugs make loading fully
error-free.
‘Snap & Lock’ Lever keeps roll
secure. No Film 'Shafts' to
confuse office users.
Ezload brochure_ALL.qxd 23.02.2006 11:14 Uhr Seite 4