Gossen Digisix User Manual
Page 4
GOSSEN Foto- und Lichtmeßtechnik
4
1
The functioning of the Digisix
1.1 Preparation and self-test
Battery
The Digisix is powered by a 3 V
Lithium battery, type CR 2032.
When the battery is running low, the signal
BAT appears in the display.
– The battery should be replaced as soon
as possible. When BAT is shown alone
in the display, the battery will need to be
replaced before further measurements
are possible.
– To replace the battery, pull out the battery
compartment placed under the eyelet for
the carrying cord.
– Remove the old battery and insert the
new one. Observe the "+" and "–"
polarity!
– Close the battery compartment
Attention! Changing the battery will cancel
all the individual values stored in memory.
Self-Test
After the new battery has been inserted,
the microcomputer will carry out a self-test.
Every display segment appears in the
display panel.
The self-test takes 10 seconds. It can be
interrupted before by pressing any button.
After the self-test, the standard settings will
be shown as set by the factory.
Standard settings
ISO
100/21°
COR
0
EV
8