Gossen MAVOSPEC - Manual (Page 9)

GOSSEN Foto- und Lichtmesstechnik GmbH 9
2.2 Config Screen
The following measurement parameters can be set on the config screen:
Auto Device automatically selects integration time. When this field
is checked, the integration time parameter is omitted.
Integration time Duration of the light measurement.
Repeat count Number of measurements which will be used to calculate
average light signal.
Flicker frequency Flicker frequency of a measured light source in Hz.
Set 0 for non-flicker light source.
Dark current Allows the calibration of the device. The device measuring head
must be attached during this procedure.