GunVault MV 1000 - Manual (Page 3)

- 2 -
Getting Started
Set your keys to the side. Don’t lock them inside the safe!
 Pull open the battery cover.
 Pull out the battery holder, by gently pulling on the ribbon.
 Insert new 9v battery. Following the Positive (+) and Negative (-) guides on
the holder.
 Reinsert the battery holder and snap the battery cover back into place.
 When power has been connected, the green light blinks one time and then
the red light blinks one time, with a long beep during the process.
 Use the factory-default code to open the unit, which is: Press each button one
time, from left to right -- 1 , 2 , 3 , 4.
 Getting ready to program
 Find the LED light in the keypad.
 It can glow either green or red. Depending upon the function being utilized.
 There is an audible beep when keys are pressed.