GunVault MVB 1000 - Manual (Page 7)

- 6 -
Key Access
NOTE: Key Access is intended for backup use only.
Insert the key into the front of the unit.
Turn clockwise to unlock the unit.
Lift the top of the MicroVault XL Biometric to open.
To remove the key, close the MicroVault XL Biometric, turn the key
counterclockwise.
.
DELETING USERS/RESETTING THE UNIT
NOTE: Individual users cannot be deleted from the MicroVault XL Biometric. All
users will be deleted together.
To delete all fingerprints currently stored on the MicroVault XL Biometric,
press and hold the Delete Button, the LED will turn red, and then press the
Start Button.
The unit will beep twice and the LED will flash green twice, indicating all
users fingerprints are deleted. If no fingerprints are stored, the red led will
flash once and beep once.
Replacing the Battery
NOTE: Low Battery Warning - When the unit is powered on, if the LED flashes
red and the unit beeps 3 times, this indicates a low battery.
Pull open the battery cover.
Pull out the battery holder, by gently pulling on the ribbon.
a) Remove all old battery.
b) Insert new 9v battery, following the Positive (+) and Negative (-) guides
on the holder.
Reinsert the battery holder and snap the battery cover back into place.