HCO SG580MB Quick Start Guide User Manual
Page 2
Sending a Picture Manually with Your SG580M Camera:
1. If you do not already have images on your camera, go ahead
and take one.
To do so, first switch your camera to the “TEST” mode.
Make sure a connection is obtained, as indicated by the 6-
digit connection code in the center of your screen.
Note, if the number does not appear, but rather the
camera shows a box with an X on the left side of the
screen for more than 30 seconds, simply shut the camera
off and try again. You may be in an area with bad signal.
Before you start taking pictures, make sure to go to
“MENU”, scroll down to “Send Mode”, and set it to
“Manual”. Hit “OK” to save changes. Hit “MENU” to exit.
Now simply point the camera where you want, and take a
picture by pressing the right arrow. You will hear a double
beep after the picture is taken.
2. Now hit “OK” to see your picture.
3. Next, to send your picture, hit “MENU”, and you should see
this screen. Hit the “OK” button to begin sending.
4. Now you should see the camera checking its connection. Once
it says
"Normal Signal",
it will go through a series of 10 steps
to send the picture.
5. If the screen says, “Send successfully”, then the picture should
now send to your specified phone or email.
Sending a Picture Automatically with Your SG580M
Camera:
1. Make sure your camera is on “TEST” mode and you have a
signal.
2. Now hit the “MENU” button and scroll down to “Send Mode”.
Make sure the mode is set to “Instant”, and hit “OK”. It will ask
you to set the maximum number of images you can send per
day after that. Hit “OK” when you are finished.
3. Next, scroll down to “PIR Interval”, and make sure to set it to at
least 2 minutes to ensure the picture has enough time to
send. Hit “OK”. Hit “MENU” to exit.
4. Then switch the camera to “ON”, close it, and wait for the red
light on the front of your camera to flash several times.
5. Now your camera can automatically take and send pictures!
Phone: 1-770-582-0004
Fax: 1-770-582-0335
Web