Breville BKC600XL - Manual (Page 17)

Setting t
Setting the
the time w
You mus
TIME’ fe
1. Press
option
blinkin
2. Press
indica
3. Press
approp
indica
4. Once t
‘OK’ b
that th
5. Press
approp
6. Once t
the ‘O
menu
Operating your Breville Gourmet Single Cup Brewer ™
continued
Menu
If the ‘BREW’ button is not pressed in 60
seconds, the LCD screen will indicate ‘OPEN
HEAD’ and the ‘BREW’ button will be disabled to
prevent accidental activation. To re-activate the
brew sequence, open the Brewing Chamber Head
by raising and lowering the Safety Locking Arm
completely.
Do not remove the Water Tank during the
brewing process.
Note
Purging the brewer
If the Brewer has not been used for more than one
week, you should renew the water from the inner
tank by purging the brewer.
1. If there is water in the Water Tank, remove the
Water Tank Lid, then gripping the handle located
on the left side of the Water Tank, lift upwards.
Discard the water, rinse and refill with bottled or
filtered water. Place the Water Tank back onto the
Brewer and replace the Lid.
2. If there is no water in the Water Tank, refill with
water. Place the Water Tank back onto the
Brewer and replace the Lid.
3. Ensure the Brewer is turned on. Raise and lower
the Safety Locking Arm on the Brewer without
inserting a K-Cup®.
4. The LCD screen will indicate ‘READY TO BREW’
and the ‘BREW’ button will illuminate and flash.
5. The LCD screen will indicate the default brew
size (7.25 oz. serving unless programmed
otherwise). Select the largest brew size
(11.25 oz. serving) by pressing the
button
on the control panel.
6. Place a 12 oz. mug on the Drip Tray Plate. The
drip tray plate and drip tray can be removed to
accomodate taller mugs and travel mugs.
7. Press the ‘BREW’ button. Hot water will flow
into your mug. When the flow stops, discard the
hot water.
8. Repeat this process 2 more times to completely
renew the water from inner tank.
16
BR9013 BKC600XL_IB_AMEND.qxp 11/10/07 21:43 Page 16