HCO Panda GSM Quick Setup Guide User Manual
Page 2
“Send Mode” should be set to “Instant”.
“Send Via” should be set to “MMS”.
18. After that, simply choose your country, cell phone operator,
and whether or not you would like to receive messages
through your phone, email, or both. Enter phone and email
addresses as needed.
Make sure the phone number is 10 digits with no spaces
or dashes.
Again, do not change the drive letter.
19. Hit “OK”, and now your settings should be complete.
20. Remove the SD card from your computer and reinsert it into
your camera.
Sending a Picture Manually with Your Panda GSM
Camera:
1. If you do not already have images on your camera, go ahead
and take one.
To do so, first switch your camera to the “SETUP” mode. If
you have just set up your camera for sending, you will see
the message “Update Success”.
Then you will see the “Checking” and “Searching…”
messages while you wait for the connection to be
obtained, as indicated by the 6-digit connection code in the
center of your screen.
Note, if the number does not appear, but rather the
camera shows a box with an X on the left side of the
screen for more than 30 seconds, simply shut the camera
off and try again. You may be in an area with bad signal.
Now simply point the camera where you want, and take a
picture by pressing the right arrow button.
2. Now hit the “OK” button to see a playback of your image.
3. Next hit “MENU”, and you should see this screen. Scroll down
to where “Send MMS” is highlighted, and hit the “OK” button
on your keypad.
4. Now you should see the camera going through a series of 10
steps to send the picture.
5. If the screen says, “Sent Successfully”, then the picture should
now send to your specified phone or email.
Sending a Picture Automatically with Your Panda GSM
Camera:
1. Make sure your camera is on “SETUP” mode and you have a
connection.
2. Now hit the “MENU” button and go to the “PIR” section with
your arrow buttons.
3. Next make sure to set the “Trigger Interval” to at least 2
minutes as the camera takes a minimum of 45 seconds to
send an image.
4. Then switch the camera to “ON”, close it, and wait for the red
light on the front of your camera to flash several times.
5. Now your camera can automatically take and send pictures.
Phone: 1-770-582-0004
Fax: 1-770-582-0335
Web