Boss Audio Systems RC-2 User Manual
Page 24
24
Playing/Overdubbing Along with a Saved Phrase
1.
Turn the PHRASE SELECT knob to select
the phrase track in which the desired
phrase is saved.
The LOOP/ONE SHOT indicator flashes rapidly while
the phrase is read from memory.
* You cannot overdub while the LOOP/ONE SHOT indicator
is flashing rapidly.
2.
Set the knob to
.
If you want to change the tempo, press the TAP TEMPO
button several times to set the tempo.
* For more details on setting the tempo, refer to “Setting the
* The tempo of a saved phrase can only be adjusted over a
limited range.
3.
Press the pedal to begin playback.
4.
When you wish to overdub along with the
phrase, press the pedal.
Each subsequent pedal press toggles between playback
and overdubbing modes.
* You can undo and redo the most recently recorded overdub
* Recording or overdubbing may stop before you are finished if
the RC-2’s memory runs out.
If this occurs, delete any unnecessary phrases (p. 33) and try
the operation again.
5.
When you are finished with playback or
overdubbing, press the pedal twice.
* Be sure to press the pedal two times within an interval of one
second.
* For more details on saving, refer to “Saving Phrases
* When you select a different phrase track while playback is
inprogress, Phrase Shift does not switch to an empty
phrasetrack, but instead the phrase being played back
continues toplay back.
If you stop with the RC-2 in this state, the
PHRASESELECT knob number and phrase track
containing thephrase you were playing back will be different,
so theindicator will flash rapidly, then flash the number of
timescorresponding to the phrase track you were playing,
andthen this pattern will repeat.
RC-2_e.book 24 ページ ２００６年１０月２７日 金曜日 午前１０時３１分