HK Audio CT 118 Sub - Manual (Page 15)

15
English
Please also read the Notes on Rigging Safety in
Chapter A of this manual.
ConTour Series™ Rigging Hardware for CT 112
and CT 115 enclosures enables the cabinets to be
flown from a single pick-point. One Aeroquip
track each is embedded in the enclosure’s lid and
in one side panel for this purpose.
Cables or chains may be used to fly cabinets.
These are connected to the Aeroquip tracks using
suitable connectors. A special mounting yoke is
available for CT 112 and CT 115 enclosures. It
attaches to the track embedded in the speaker’s
lid.
1.1 Flying Enclosures with Cables or Chains
Figure 22: The rigging track in the lid
Figure 23: Attaching the rigging cable
1.2 Mounting Yoke for CT 112 and CT of 115
Enclosures
The mounting yoke for CT 112 and CT 115
enclosure is attached to the Aeroquip track on the
lid using two M10 screw attachments (M10
studs). Insert an M10 stud into the first and last
points on the track, affix the locking ring into its
designated hole and set the mounting yoke in
place. Attach the yoke using the knob screws.
Secure the speaker and yoke hanger with a
suitable arrest wire to prevent the enclosure from
falling. Use the HK AUDIO
® EB 10 eyebolt for this
purpose. Remove the countersunk screw on the
speaker’s rear panel and insert the EB 10 eyebolt
in its place. Run the safety cable through the
eyebolt.
Figure 24 a, b: Inserting studs
Figure 25: Attaching mounting yokes to CT 112 and
CT 115 enclosures
Figure 26: Attaching the EB 10 eyebolt and arrest wire
Loosen the side-mounted toggle screws to adjust
the tilt angle.
The CT 112/ CT 115 mounting yoke’s maximum
load-handling capacity is 34 kg. No more than one
enclosure may be mounted to it.
Figure 26: Attaching the EB 10 eyebolt and
arrest wire
Figure 25: Attaching mounting yokes to CT 112 and
CT 115 enclosures
Figure 24 a, b: Inserting studs
Figure 23: Attaching the rigging cable Figure 22: The rigging track in the lid
C Rigging ConTour Series™ CT 108/ CT 112/
CT 115 Enclosures