Human Touch HT-5040 Massage Chair - Manual (Page 4)

humantouch.com
4 5
ENGLISH
Unpack the box
1. Unfold the chair
Remove all packaging materials from the
chair. Pull up on the backrest to unfold the
chair to an upright position. The backrest
locks into place automatically.
2. Install the backrest pad
Attach the top backrest pad flap to the top of the
backrest. Smooth the two bottom flaps under the bottom
of the backrest. Attach each side flap to the side of the
backrest. All flaps attach using hook and loop fasteners.
Chair Seat Pad Backrest Pad Head Pillow
4. Attach the seat pad
Use the remote control Legs Up setting to raise the footrest to a horizontal position. Attach
the seat pad to the back of the seat, using the hook and loop fasteners. Wrap the flap on the
front of the seat pad around the chair frame and attach it to the top of the chair frame using
the hook and loop fasteners.
5. Attach the head pillow
Flip the two straps on the back of the headrest up and
over the top of the chair. Attach the head pillow to the
straps using the hook and loop fasteners. Adjust the head
pillow height for maximum comfort.
3. Power on
Plug the power cord into a grounded power
source. Turn the master power switch
(on the bottom center of the chair back) to On.
get ready
Your Human Touch massage chair requires some
simple assembly (no tools required). Just install
the backrest pad, the seat pad and the head
pillow, and you’re done!