Human Touch HT-1650 Massage Chair - Manual (Page 5)

www.humantouch.com
8 9
ENGLISH
Install the Fine Floor Protector
Notched end of Floor Protector slides under foot
and calf massager (textured side up); hook-and-loop
fasteners attach to top side of the chair cross-bar.
1. Deploy the foot and calf massager
Press the legs-up button on the remote
control to fully deploy the foot and calf
massager. Pull up on the footrest release
handle (located on the right-hand side of the
footrest), then rotate the footrest away from
the chair until there is enough room to reach
underneath the front of the chair.
2. Place the Fine Floor Protector
For your safety, before installing the
Floor Protector, be sure to turn off the
chair at the main power switch and
unplug the power cord.
Lift the foot and calf massager wheels a few
inches off of the floor. With the hook-and-
loop fastener strip facing down, slide the
Floor Protector into place as shown.
USING THE FINE FLOOR PROTECTOR
Your Human Touch massage chair is a powerful
precision instrument. An optional Floor Protector is
included to ensure smooth operation on fine wood,
tile, or thick-pile carpeted floors.
Installing the Floor Protector guards against possible
floor damage due to long-term, repeated foot and calf
massager deployment.
3. Secure the Fine Floor Protector
Align the hook-and-loop fasteners on the underside of
the Floor Protector with the hook-and-loop fasteners on
top of the chair crossbar. Press the hook-and-loop edge
of the Floor Protector firmly into place to secure it.
4. Complete the installation
Remove any packaging materials left under or around
the chair during installation. Return the foot and calf
massager to its original locked position. Plug in the
chair and turn it on. Press the legs-down button to
retract the foot and calf massager.
Remove the Fine Floor Protector before moving the chair to a new location.
get ready
part II