Human Touch iJoy HT-2720 Robotic Massage Chair - Manual (Page 4)

humantouch.com
4 5
ENGLISH
Your Human Touch ® iJoy ® massage chair
requires some simple assembly. Simply
attach the backrest to the chair base,
plug it in, turn it on, and you’re done!
Unpack the box
Chair base
2. Plug it in
Plug the power cord into a grounded 110-volt power source.
Setting the Child Safety Lock to the Lock position prevents the power
switch from being turned on. Keep the child safety lock in the Locked
position when unattended, to prohibit children from using the chair.
4. Power on
Turn the master power switch to On (located on the back of the chair).
3. Child safety lock
Make sure child safety lock is set to Unlock.
The Human Touch ™ massage chair power panel offers a convenience outlet,
which enables you to plug in a low-wattage appliance such as a lamp or
laptop. Do not plug in appliances that use wattages higher than 1 AMP, such
as a vacuum or a hair dryer.
1. Attach the backrest to the chair base
Before installing the backrest, remove the two screw knobs from the bottom
of the backrest. Align the guides on the lower sides of the backrest with the
track on the chair base, then slide the backrest firmly onto the chair base.
From the bottom of the backrest, install and hand-tighten the two screw
knobs. Verify that the two screw knobs are installed and tightened before
using the chair.
Backrest
CAUTION: Be sure all cords and fingers are out of the way before
installing the backrest, to avoid damage or injury. You may want to
use two people for installation, as the backrest is heavy.
get ready
Locked
Unlocked
ON
OFF