Human Touch PC-500 Perfect Chair - Manual (Page 4)

5
humantouch.com
4
get ready Your Human Touch ® Perfect Chair ® requires some simple assembly. Just
attach the backrest frame, pads, arm caps, and head pillow, and you’re done!
5
Slide the body pad onto the lower part of the chair frame,
making sure that the frame slides into the fabric pocket located
on the bottom side of the pad.
ATTACH THE BODY PAD
1. Slide the body pad onto the chair frame.
Smooth the body pad into place, from the footrest toward the
backrest. The pad is automatically secured using the hook
and loop fasteners.
1. Raise the chair to an upright position.
ATTACH THE BACKREST FRAME
For your convenience, and to better position the chair for the remaining
assembly, plug in the chair, then use the electric recline lever to adjust the
chair to an upright position.
Using the Phillips-head screwdriver (provided), remove the two
screws from the headrest frame. Retain them for use in step 4.
With the backrest frame positioned so that the headrest can
tilt forward, slide the two ends of the backrest frame into the
open tube ends of the chair base.
Using a Phillips-head screwdriver, replace the two headrest frame
screws, securing the headrest frame to the backrest frame.
2. Remove the backrest frame screws.
3. Insert the backrest frame into the chair base.
4. Replace the backrest frame screws.
UNPACK THE BOXES
Body pad
Arm cap (2)
Head pad Head pillow Phillips-head
screwdriver
Headrest frame
Chair frame
Head sock
CAUTION: Plug the chair into an appropriate power source. Be sure that
the power cord lies beneath the mechanics located underneath the chair.
Pull the chair canvas firmly upward as far as it will go, wrap the
top flap around the backrest frame and secure it using the hook
and loop fasteners. It is important that the canvas be stretched
tight to provide proper back support.
5. Install the canvas backrest support.
Top flap
Canvas
2. Secure the body pad.
Screw (6)