Get ready – Human Touch PC-510 Perfect Chair User Manual
Page 4
5
humantouch.com
4
get
ready
5
UNPACK THE BOXES
Chair frame
Headrest frame
Head sock
Arm core
Body pad
Arm cap (2)
Head pad
Head pillow
3/16-inch
Allen key
Phillips-head
screwdriver
Lumbar pillow
Some pad sets include a separate
lumbar pillow instead of the upgraded
body pad with built-in lumbar support.
1. Raise the chair to an upright position.
ATTACH THE BACKREST FRAME
For your convenience, and to better position the chair for the remaining
assembly, plug in the chair, then use the electric recline lever to adjust the chair
to an upright position.
Using the Phillips-head screwdriver (provided), remove the two
screws from the headrest frame. Retain them for use in step 4.
2. Remove the backrest frame screws.
CAUTION: Plug the chair into an appropriate power source. Be sure that the
power cord lies beneath the mechanics located underneath the chair.
Slide the body pad onto the lower part of the chair frame,
making sure that the frame slides into the fabric pocket located
on the bottom side of the pad.
ATTACH THE BODY PAD
1. Slide the body pad onto the chair frame.
Smooth the body pad into place, from the footrest toward the
backrest. The pad is automatically secured using the hook
and loop fasteners.
Using a Phillips-head screwdriver, replace the two headrest frame
screws, securing the headrest frame to the backrest frame.
4. Replace the backrest frame screws.
Pull the chair canvas firmly upward as far as it will go, wrap the
top flap around the backrest frame and secure it using the hook
and loop fasteners. It is important that the canvas be stretched
tight to provide proper back support.
5. Install the canvas backrest support.
Top flap
Canvas
2. Secure the body pad.
Your Human Touch
®
Perfect Chair
®
requires some simple assembly. Just
attach the backrest frame, pads, arm caps, and head pillow, and you’re done!
Screw (4)
Screw (6)
With the backrest frame positioned so that the headrest can
tilt forward, slide the two ends of the backrest frame into the
open tube ends of the chair base.
3. Insert the backrest frame into the chair base.