JK Audio BlueKeeper - Manual (Page 7)

18
FAQs
? What is the range of the Bluetooth transmitter/receiver?
! BlueKeeper will transmit and receive audio signals up to 15 feet
(5 meters) from your Bluetooth device.
? Can I send and receive audio at the same time?
! Yes you can! You can have full duplex conversations with your
microphone sent to the Left channel of the stereo line output
and the Bluetooth audio sent to the Right channel.
? If I have an audio source connected to the Send 2 input, will
that audio also be present at the Output mini jacks?
! Yes, the stereo input will be added to your microphone (or line
level) audio from the XLR Send 1 input and both will be sent to
the Mono Out and to the Left channel of the Stereo Out. This
combined input will also be sent to the Bluetooth connection.
? Can I pair my BlueKeeper to two cell phones and send my
audio to two locations simultaneously?
! No, your BlueKeeper can only be paired to one Bluetooth en-
abled device at a time.
? Will the audio gateway provide phantom power for a con-
denser mic?
! No, this device will not provide phantom power. If you connect a
microphone directly to the BlueKeeper, you should use a dy-
namic mic.
? How do I record onto my computer and edit the files?
! You need to purchase or download any audio editing software of
your choice. You may also need to edit the audio configuration
files on your computer or in your software to allow recording in
stereo. BlueKeeper just enables you to access audio from your
Bluetooth cell phone.
7
Features—Rear View
Figure 2: Rear View
12. Bluetooth antenna - do not obstruct.
13. Caller Output - Male balanced XLR output contains only the
caller’s voice at line level.
14. Send 1 Input - Female balanced XLR input for signals going
out to the cell phone. Mic or line level input.
15. Mic / Line switch - Sets the front end sensitivity of the Send 1
XLR jack. Set to Mic if you intend to connect a dynamic micro-
phone directly to the Send 1 jack. Set to Line if you are con-
necting to the output of a mic pre-amp or mixer.
16. Send 2 Stereo Input - 3.5mm mono mini jack input for signals
going into the cell phone. Line level.
17. Stereo Output - 3.5 mm stereo mini jack line level output con-
tains both Send and Caller audio channels with levels deter-
mined by the Send 1 and Send 2 level controls and the Caller
level control. Left channel contains your local Send audio and
right channel contains the Caller's audio from the cell phone.
18. Mono Output - 3.5 mm mono mini jack output contains a mix of
Send 1, Send 2 and Caller audio with levels controlled by
each of the input control knobs on the front of the unit. This
output is at Mic level and is suitable for connecting to the Mic
input on a computer or other recording device.
19. Power Jack - For connection only to the supplied 9VDC regu-
lated power supply.
12 13 14 15 16 17 18 19