JK Audio BlueKeeper - Manual (Page 8)

8
Connection
Figure 3: Basic Connections
Although each application may require a slightly different setup, the
following diagram shows a primary configuration.
For a direct connection to BlueKeeper:
•
Send Audio - Connect a dynamic microphone cable to the Send
1 jack on the BlueKeeper. Be sure to set the Mic/Line button to
the “Mic” position.
•
Output - Connect a stereo cable from the mini-jack “Stereo Out”
on the BlueKeeper to the “Line In” on your computer sound card
or other recording equipment that has a stereo input, or connect
a mono cable from the mini-jack “Mono Out” on the BlueKeeper
to the “Mic In” on your laptop computer or other recording equip-
ment.
•
Power - Connect the supplied DC power supply to the back of
the BlueKeeper and then to an AC power outlet.
•
Your BlueKeeper is now ready to take calls. You can establish a
connection to your Bluetooth enabled cellular phone (see pages
16-17) and place or receive a call.
•
Set the “Send” level control so that while you are speaking into
the mic, the Send LEDs on the BlueKeeper light the -20 dB green
LED consistently and flash the -9 dB green LED with only occa-
sional flashes on the -3 dB red LED. Set the “Caller” control for
good recording level of the caller audio at the output jack.
Set to
“Mic”
Mic
in
Sound Card
Computer
Line
in
Line
out
Connect Stereo Out
to PC Line In or to
Stereo Line Input on
mini recorder