ETI Sound Systems, INC LHEC20 - Manual (Page 10)

8 9
MaTRiX-600 REaR PaNEl CONTROlS & CONNECTORS
1. lOudSPEAkER OuTPuTS – RIGHT
and lEFT: Connect to RIGHT and LEFT
speakers accordingly. Use only
speakers supplied with the system.
The Matrix-600 is equipped with
combo output connectors which
accept both Speakon™ and 1/4”
plug speaker cables for flexibility. The
Matrix-600 comes includes a pair of
20’ high quality speaker cables with
1/4” plugs. We encourage you to
upgrade these speaker cables to
cables with Speakon™ connectors on
both ends. The speaker cables must
have a standard connection, (1-)
connected to ground and (1+)
connected to output.
2. PREAMP OuTPuTS l/R: These 1/4”
TRS Jack outputs could be used to
connect the mixer of the Matrix-600
to an external sound system, includ-
ing connections to a mixer, preamp
or power amplifiers. This provides
you the flexibility of using the Matrix-
600 with an existing sound system.
The power amplifier built-in to the
Matrix-600 will automatically discon-
nect. Make sure your external sound
system is OFF before making such a
connection.
3. POWER AMP INPuTS l/R: Use these
1/4” TRS Jack inputs to connect the
power amplifier of the Matrix-600
system to an external source, such as
an outboard audio mixer. This
connection will automatically discon-
nect the amplifiers from the rest of the
unit. The signal from the front panel
of the Matrix-600 mixer will not be
routed to the amplifiers. Make sure
the Matrix-600 is turned OFF and the
external sound source’s level is set to
zero before making such a connection.
4. MONITOR OuTPuT: Use this 1/4”
TRS Jack output to connect a
powered monitor (or a power
amplifier with a passive monitor) to
your Matrix-600 system. You can
control the overall level of the
MONITOR output, the level of effects
mixed to the MONITOR output, as
well as the individual channels levels
going to the MONITOR output with the
corresponding controls on the mixer.
5. RECORd OuTPuT: Connect these stereo