JK Audio RIU-IP - Manual (Page 10)

10
?
The IP address you have assigned to the RIU-IP is already
in use on my network system. How do I change the
address to something else?
!
Please see Pages 6-7 for more information on accessing the
Configuration page.
?
Why do I get invalid responses sometimes when I turn the
RIU-IP on?
!
The RIU-IP needs about 30 seconds to complete its boot-up
sequence. The red LED only indicates that the unit is receiving
power. There are no visual indicators to show when it is ready
for use so please wait at least 30 seconds each time you
energize this device before sending commands.
?
Can I make a longer cable for the Remote Port?
!
Yes, you can, but be aware that even though they have the
same size connectors that will fit into each of the jacks, the
Remote Port cable is not the same as an Ethernet cable. An
Ethernet cable is an 8-conductor cable with RJ-45 connectors.
The Remote Port uses a 10-conductor cable with RJ-50
connectors and the connector should be reversed on one end.
?
Why does the RIU-IP ignore some of my commands?
!
The transmission of data through the serial port interface can
be a little slow sometimes. When commands overlap, some
may be dropped. If a command is missed, simply repeat the
command.
?
How do I connect to my innkeeper from another location,
such as when I am traveling in another state?
!
Talk to your computer network administrator for remote access
instructions for your site. Once you have access to the network,
all the other commands will function as if you were in the same
building.
FAQs