K-array KA24 - Manual (Page 16)

KA24/KA84
PRELIMINARY 16
DELAY
The Delay page allows users to independently set the
delays for the four output channels (up to 3.5 mt) and for
Channel 3 and Channel 4 input channels (up to 114 mt).
Pressing on a delay value, users can set the delay in ms
or in mt. Press the OK button to return to the Delay page.
CONFIGURATION
Before connecting the speakers to the amplifier, follow
the instructions below.
Warning. Failure to follow these instructions
could result in serious damage to the
speakers connected to the amplifier!
Go to the Configuration page and press the SETUP
button Insert the model and the number of speakers
connected to Output A1. Press the arrow button on the
top right corner.
Insert the model and the number of speakers you
want to match to the previous ones. For example if you
have two KP102 mid-high arrays connected to an A1
output and a KMT21P sub connected to another output
(or to another amplifier) select KMT21P to the A1 Out
Match page and the DSP will compute automatically the
crossover setting to obtain a perfect match between the
speakers. Press the arrow button on the top right corner.
Repeat step 2 and 3 for all other outputs. At the and
you will return to the main Configuration page. Press
APPLY to load all settings. The DSP will automatically
adjust the output gain and the crossover on each output
channel to match the requirement for the speakers
connected.
Warning . If you are using speakers with selectable impedance, pay
attention to set the value indicated in the Configuration page!