Kino Flo Celeb 200 DMX LED - Manual (Page 16)

16
Inserting Barndoors
Troubleshooting
Position the barndoors
alongside the extruded
edge of the fixture. Align the
thumbscrews with the adjust-
able receptacle holes in the
fixture and insert into place.
Lock the barndoors by turning
the silver thumbscrew.
To remove, reverse the
procedure.
For replacement screws,
use M5 Metric size screws.
Note: To adjust the place-
ment of the receptacle holes,
use a pointed tool (such as
a pen) to slide the holes
within the extruded edge.
BRD-CE2
Display Protection Condition Description Normal Condition Cause/Solution
OCP Over Current Protection Shut down current 2.45A
in excess of 20%
2.04A @ 100% dim Repair Service
Center
OVP Over Voltage Protection Shut down voltage @
excess 30V
Below 28V Wrong Battery
or 24V Battery
w/ too high
Open Voltage
UVP Under Voltage Protection Shut down voltage @
below 17V
Excess 18V Dead Battery
OTP Over Temperature
Protection
Shut down temp @
120°C (LDM board side)
Below 120°C @
LED array
Cool Down
OPP Open Protection Open circuit No open Repair Service
Center
SCP Short Circuit Protection Short circuit No short Repair Service
Center